Malfunctions on the direct shift transmission
Transkrypt
Malfunctions on the direct shift transmission
Service Info Malfunctions on the direct shift transmission 7-speed transmission with dry double clutch Manufacturer:VW Models: Scirocco (137) Passat CC (357) Golf Plus (5M1/521) Golf/Jetta (1K/5K1) Touran (1T) Transmission:0AM In the direct shift transmission, the gear is changed by the mechatronics. The mechatronics consist of a control unit and an electrohydraulic control unit. The integrated hydraulic pump is electrically driven and provides an operating pressure of 70 bar. As a result of the increased power required by the hydraulic pump, a fuse must be used that is designed for a high continuous load. A 30 A fuse is installed ex works for the power supply to the mechatronics. In individual cases, it is possible that an incorrectly dimensioned 15 A fuse may have been installed, which could cause a range of malfunctions on the direct shift transmission. The following error memory entries may have been stored in the transmission control unit: • Issued 06.2013 LuK 0041 Technical content subject to change Listed OE-numbers are for comparison purposes only. © 2013 Schaeffler Automotive Aftermarket • • • • P0562/21148 Supply voltage for the electric motor is too low P177F/21065 Unacceptably high voltage drop in the electric motor P175F/21098 No valid basic calibration for the transmission P189C/21247 Accumulator diagnosis not possible P174A/21108 Valve open load coupling Phone: +44 (0) 14 32 264 264* Fax: +44 (0) 14 32 375 760 [email protected] www.schaeffler-aftermarket.com * Calls from within the UK 08457 001100 Image 1: The fuse for the mechatronics is usually located in the engine compartment fuse holder In the event of malfunctions on the direct shift transmission, first check whether a functioning 30 A fuse has been installed for the power supply to the mechatronics. The precise installation location of the fuse depends on the vehicle and can only be located using the current flow diagram or the on-board literature. Faulty or incorrectly dimensioned fuses must be replaced. A 30 A fuse is essential for the direct shift transmission to operate without any malfunctions. Observe the specifications of the vehicle manufacturer! Spare parts and technical information can be found under www.schaeffler-aftermarket.com or www.RepXpert.com.