Adapter EMMC for Riff BOX - RC1000 allows a very - Multi

Adapter EMMC for Riff BOX - RC1000 allows a very simple repair phones with blocked JTAG
access (GT-i9300 / N7100 / N719 / N7102, etc.), repair phones with damaged JTAG points/pads
(access to ROM2 by EMMC) or read/write EMMC applicable for the data recovery/analysis. Using
the adapter you can perform format EMMC or low-format (in case of damage EMMC), CMD42
Lock/Unlock/Pasword reset or Samsung eMMC Factory Format. Our adapter allows you to connect
in ISP mode (directly onto your phone without removing the EMMC) or Direct (by removing the BGA
soldering and the corresponding memory fields or using adapter).
Advantages of the use of an adapter RC1000:
- Full control over the VCC / VCCQ by connection of external power from USB
- The ability to turn ON/OFF Pull-UP CMD and DATA (Dat0) to increase signal levels and improve
stability
- Lack of communication problems by applying the same path length for the transmission signals
- The ability to connect the IDC 10 pin connector
- allows use BGA adapters used in CHIP-Off for Direct Mode
Features:
eMMC/SD reading info, browsing through OCR, CID, CSD (and EXT_CSD for eMMC only)
registers fields, edit separate fields and writting back to card, reading/writting eMMC cards MCUs
internal firmware, etc
eMMC Firmware Update option
eMMC Firmware Reading option
CMD42 Lock/Unlock functionality for eMMC - user can set/change/remove password to
protect/unprotect (lock/unclock) the User Area Partition
User Area Partition Forced Erase to erase Locked User Area Partition and to reset Device
lock/unlock state and password (CMD42s consequences)
Samsung Factory Erase which erases and re-formats the Samsung eMMC chips.
Output signals on the adapter:
- GND
- CMD (ON/OFF DipSwitch to enable/disable pullup signal - 100 ohm)
- CLK
- Dat0 (ON/OFF DipSwitch to enable/disable pullup signal - 100 ohm)
- VCC (voltage regulation using two modes - 2.8V / 3.3V)
- VCCQ (regulation voltage range in three modes - 1.8V / 2.8V / 3.3V)
Pinout GPG eMMC adapter
Pinout RC1000
Note: Each of the signals is described on the PCB
Photo adapter:
Movie showing the adapter in connection stage:
Set includes
- Adapter RC1000 for Riff BOX
Niniejszy opis nie stanowi oferty w rozumieniu Kodeksu Cywilnego. Multi-COM Sp. z o.o. zastrzega
sobie również prawo do błędów w powyższym opisie produktu. W celu weryfikacji prosimy o kontakt
z naszym Działem Sprzedaży.
Multi-COM Sp. z o.o.
ul. 22-go Lipca 31b
36-100 Kolbuszowa
POLSKA
tel. 0048172270025, 0048172275045
Infolinia: 0801671717
Skype: Multi-COM