Installation and Service Manual

Zakład Wytwórczy Aparatów Elektrycznych Sp. z o.o.
ul. Gdańska 60; 84-300 Lębork
Tel/Fax: (059) 86-336-15 / 86-333-86
www.zwae.com.pl e-mail: [email protected]
INSTALLATION AND SERVICE MANUAL
INSTRUCTION FOR GDS
SWITCH DISCONNECTOR
ZWAE Sp. z o.o.
Nr 1/2004
Zakład Wytwórczy Aparatów Elektrycznych Sp. z o.o.
ul. Gdańska 60; 84-300 Lębork
Tel/Fax: (059) 86-336-15 / 86-333-86
www.zwae.com.pl e-mail: [email protected]
1. Introduction.
Dear Customer !
The purpose ofthis instruction is to provide information on switch disconnector type GDS for outdoor
use.
The instruction includes technical data, design description as well as recommendation foradjustment and
service. The instruction has been issued with an intention to help in proper installation, servicing and
operation of the switch disconnector.
Strict observance of requirements specified in this instruction ensures troublefree service of switch
disconnectors and is a condition of validity of manufacturer's guarantee. Therefore, it is necessary for the
User, to be acquainted with this instruction, before the switch disconnectors are installed and put into
operation.
Zakład Wytwórczy Aparatów Elektrycznych Sp. z o.o.
ul. Gdańska 60; 84-300 Lębork
Tel/Fax: (059) 86-336-15 / 86-333-86
strona Internetowa : www.zwae.com.pl
e-mail: [email protected]
1. Application.
The MV outdoor switch disconnector of type GDS this is construction produced many years about
very good the parameters and the simple construction. One - and three -phase switch disconnectors are
designed for closing and opening not loaded electrical circuits in outdoorA.C. Substations.
2. Advantages.
- the simple construction with exploitation proven mechanisms
- reliability of working
- good technical parameters
Strona 2/4
Zakład Wytwórczy Aparatów Elektrycznych Sp. z o.o.
ul. Gdańska 60; 84-300 Lębork
Tel/Fax: (059) 86-336-15 / 86-333-86
www.zwae.com.pl e-mail: [email protected]
3. Installing.
1.To install on pillar clamping ring with the help of screw thread M16
for round pillarj
for square cement pillarj
2. To install retaining beam with the help of screw thread M12.
3. With the help of connection clips fix pole to retaining beam 80x80mm
Strona 3/4
Zakład Wytwórczy Aparatów Elektrycznych Sp. z o.o.
ul. Gdańska 60; 84-300 Lębork
Tel/Fax: (059) 86-336-15 / 86-333-86
www.zwae.com.pl e-mail: [email protected]
4. To install driving beam 40x40mm
5..To install driving lever.
5..View assembled switch disconnector
5. To install the slideway of tie rod
for round pillar
for reinforced cement pillar
Strona4/4