Soft PAPE thermoforming film

Soft PAPE thermoforming film
2015-12-07 14:40:20.929304
2
Esta oferta não constitui informação comercial
Adres instytucji/firmy ogłaszającej ofertę
F.H.P. PAK Sp. Z o.o.
87-100 Toruń .
Bolesława Chrobrego 117 .
Poland
Pessoa de contato
Anna Karbowska
[email protected]
Tel: 0048691842721
www.pak.torun.pl
Descrição
Soft PAPE film production at Kalibra Sp. z o.o., based on the blow moulding
technology, utilises an innovative cooling system of the extruded sleeve. Rapid
cooling of the blown sleeve is achieved by passing it through a cold water tank. By
rapid cooling the "freezing" of the amorphous structure is obtained, which in turn
results in its substantial part and higher percentage vs crystalline structure. Physical
and mechanical features of the film, such as transparency, gloss and thermoforming
properties, depend on the crystalline phase. The smaller part of crystalline phase vs
amorphous phase the better performance and optics will be achieved. A similar
phenomenon occurs in the production of glass. It is worth quoting here a publication
of BASF - one of the main producers of polyamide, known under the trade name,
Ultramid. [1] The publication presents studies performed on 50 micron PA films
produced from Ultramide. The results show the relationship between the
crystallization and haze, expressed as a percentage value, and thermoformability,
defined as the thickness at the thinnest points of the film, in formed shapes. At 38%
crystallization and haze of 2.8%, the measured film thickness at the thinnest point,
was 12 microns. At 20% crystallization and haze of 0.4%, the measured film
thickness at the most thinnest point, was much higher and reached 18 microns. High
3
transparency film, with light transmission ratio (LTR) well above 90%, indicates high
proportion of amorphous phase, and proves extremely good thermoformability of
multilayer films produced by Kalibra Sp. z o.o. . Such a high proportion of amorphous
phase is not achievable with any other technology of film with PA content
coextrusion. Kalibra Sp. z o.o. produces coextruded multilayer films with a total
thickness of 50 to 300 microns. These are six-layer-films, of PA / adh * / PA / adh / PE
/ PE structure, where adh* means polymer binding.
Nabywcy z zagranicy
●
●
●
●
●
●
●
●
●
●
●
●
●
●
Algieria
Austria
Azerbejdżan
Belgia
Białoruś
Czarnogóra
Francja
Litwa
Republika Południowej Afryki
Słowacja
Słowenia
Tajwan
Ukraina
USA
CPV
●
Matérias plásticas em formas primárias
Tipo de oferta
venda
4
Prazo para apresentação das propostas
04.06.2016
Válido de
07.12.2015
Sector
Wyroby z gumy i tworzyw sztucznych
Possível volume de produção
10000
O valor mínimo do contrato
500.00
Moeda
Empresa estrangeira
SIM
5