short description KLEIB PROFESSIONAL C5 ACRYLIC PLASTER
Transkrypt
short description KLEIB PROFESSIONAL C5 ACRYLIC PLASTER
KLEIB sp. z o.o. Kolejowa 15 - 17 87-880 Brześć Kujawski short description KLEIB PROFESSIONAL C5 ACRYLIC PLASTER USED FOR MAKING OUTSIDE STUCCO TEXTURE WALLS KLEIB PROFESSIONAL C5 ACRYLIC PLASTER USED FOR MAKING OUTSIDE STUCCO TEXTURE WALLS. KLEIB PROFESSIONAL C5 is part of a product set used for the KLEIB building insulation system in compliance with Technical Approval no. AT-15-8239/2013 issued by the Building Research Institute in Warsaw. USE KLEIB PROFESSIONAL C5 is an acrylic plaster used for making outside plasters on reinforced layers of the KLEIB thermal wall insulation system. SUBSTRATE PREPARATION The substrate should be solid, strong, dry, flat and completely devoid of any damage or uneven surfaces, as these defects might be visible after the plaster has been applied. Prime the substrate with KLEIB PROFESSIONAL C3 and after it has dried (but no later than after 72 hours have passed) apply the KLEIB PROFESSIONAL C5 acrylic plaster. PLASTER PREPARATION The plaster is provided ready-for-use. After opening the bucket, the contents should be mixed in order to smoothen the product's consistency. APPLICATION Apply the plaster manually with a stainless steel finishing trowel. Always use the same technique and trowel the plaster in the same intervals after it has been applied to the surface, using a PVC (or similar) trowel. Work on a given surface within a single technological cycle (without any interruptions). The whole process should be finished no later than 72 hours after priming the surface. PRODUCT CONSUMPTION Plaster thickness 1.5 mm 2 mm Average consumption in kg/m2 2.5 ÷ 3 3 ÷ 3.5 STORAGE AND TRANSPORTATION Fasakol F5 must be stored in airtight buckets in dry conditions and above zero temperatures for a maximum of 12 months after the production date found on the label. TECHNICAL SPECIFICATION Bulk density Percentage of dry substance in 450°C Percentage of ash in 900°C 2.0 g/cm3 ± 10% 86.5 % (-4.3 / +8.7) 90.7 - 94.7 50.8 - 54.8 Resistance to shrinkage cracks Mortar preparation temperature Surface and ambient temperature during application No cracks in layers with thickness that is equal to the diameter of the largest grain From +5°C to +25°C From +5°C to +25°C This product is compliant with Technical Approval no. AT-15-8239/2013. National Declaration of Conformity no. ... for the KLEIB insulation system. This product comes with a Hygienic Approval. Certifying authority that participated in the evaluation of conformity: Building Research Institute Filtrowa 1, 00-611 Warsaw. Bar code as per label with C5 code (5908272625066). Construction mark B. MANUFACTURER KLEIB sp. z o.o. Kolejowa 15 - 17 87-880 Brześć Kujawski Phone/Fax: 54 233 82 83 PRODUCED IN THE FOLLOWING PLANT: KLEIB sp. z o.o. Kolejowa 15 - 17 87-880 Brześć Kujawski Production date: